Quasar CM-3211 Series Installationsanleitung PDF herunterladen (Seite 77)

Quasar CM-3211/CM-4221 Series User and Installation Guide

 Upload Image by E-Mail – Selecting this option enables you to assign an e-mail address

and configure various parameters, as shown in Figure 55: Application – Upload Image by

E-Mail. When tampering is detected, event images will be sent to the designated e-mail

address.

Specify two e-mail addresses to use from the drop-down menu. Select the number of

frames for the pre-trigger and post-trigger buffers from the drop-down menu of 1-20

frames.

Check the box for Continue image upload if you wish to use this option. To specify the

length of time for the upload, click on this radial button and enter the number of

seconds. To upload during the active trigger, click on this radial button. Finally, select the

number of frames per second from the drop-down menu next to Image frequency.

Note:

Make sure SMTP or FTP configuration has been completed. See section Mail

and FTP for further details.

 Send HTTP notification – Check this option, select the destination HTTP address, and

specify the parameters for HTTP notifications. When the tampering alarm is triggered, the

HTTP notifications can be sent to the specified HTTP server. See Figure 56: Application –

Send HTTP Notification.

File Name

The uploaded image’s filename format can be set in this section. Select the one that meets your

requirements.

Save

Click Save to save all the specified tampering alarm settings.

7.3.12 Storage Management

You can locally record up to 32GB on a microSD/SDHC card. The Storage Management page shows

the capacity information of the card and a recording list of all the recording files saved on the

memory card. You can also format the card and implement automatic recording cleanup on this

page. To implement microSD/SDHC card recording, see Recording.

Note:

Format the microSD/SDHC card when using it for the first time. Formatting is

also required when a memory card has been used on one camera and is then

transferred to a camera that uses a different software platform.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 136 137

Keine Kommentare

Quasar CM-3211 Series Installationsanleitung Seite 77