Quasar CM-3211 Series Installationsanleitung PDF herunterladen (Seite 26)

Installation

5.6 Mounting Instructions

The following are mounting instructions for the CM-3211/4221 series cameras.

 CM-3211/4221-10-I and CM-3211/4221-11-I Mounting Tips

 Mounting the CM-3211/4221-00/10/10-I Indoor Camera

 Mounting the CM-3211/4221-01/11/11-I Outdoor Camera

5.6.1 CM-3211/4221-10-I and CM-3211/4221-11-I Mounting Tips

To eliminate IR reflection:

1. Clean the bubble from dirt and finger prints.

2. Make sure the bubble has no scratches.

3. Fasten the screw that secures the snap-in chassis in order to have the rubber sealed against

the bubble.

4. Avoid aiming the IR where there are nearby objects closer than the scene of interest which

might reflect back into the lens.

5.6.2 Mounting the CM-3211/4221-00/10/10-I Indoor Camera

1. Do one of the following:

 For drilled wall or ceiling mounting:

a) Use the base plate as a template, mark with a pointed pencil, the mounting surface

through the plate holes where the four screw holes will need to be drilled

(see Figure 12).

Caution:

Before marking and drilling the holes, ensure that the base plate alignment is

oriented correctly so that the required camera field of view can be achieved when

the system is assembled.

Figure 12: Base Plate Used as a Template to Mark Drilling Locations

b) In the marked locations, drill each hole using a drill-bit of a slightly smaller diameter

than the supplied screw anchors (molly-plug anchor). You want to achieve a snug

insertion so that the plug expansion holds firm after the screws are screwed in.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 136 137

Keine Kommentare

Quasar CM-3211 Series Installationsanleitung Seite 26