Quasar CM-3211 Series Installationsanleitung PDF herunterladen (Seite 29)

Quasar CM-3211/CM-4221 Series User and Installation Guide

• For bracket, pole and pendant installations:

a) Thread the power and Ethernet cables and any other wires (such as a relay output,

alarm input, audio in, or audio out) through the wire entry.

b) If you are not wiring from within the wall, you can run the wires through the cable

entry hole on the side of the dome.

c) If necessary, you may need to unscrew the disk from the cable entry hole and screw

it into the alternate unused conduit cable entry hole in order to seal it.

Figure 15: Top and Side Cable Entry Openings to Dome

Tip:

Even if you are not using alarm inputs and audio input/output at the time of

installation, you may want to consider pre-wiring these connections for future use.

Note:

The power cable is not required if using PoE.

3. Thread the wires through the base plate and screw it to the predrilled wall, ceiling,

CM Series Mini-Dome Recessed Mount, CM Series Mini Mini-Dome Corner Mount, or 4S

electrical box. Check that the installation is not flimsy, will not wobble, and is flush with the

mounting surface.

Tip:

Use shims for shoring up mounts on uneven surfaces.

4. Snap the camera module back on the base plate with the wiring threaded through the gap at

the module base and then screw in the module-fastening screw.

Figure 16: Replacing Camera Module onto Base Plate

5. Plug the Cat 5 cable into the camera Ethernet port and, if needed, plug the power terminal

block into the power terminals.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 136 137

Keine Kommentare

Quasar CM-3211 Series Installationsanleitung Seite 29