Quasar CM-3211 Series Installationshandbuch PDF herunterladen (Seite 51)

CCM-3211 Series Installation Manual

Enable IP Filter

Check the box to enable the IP Filter function. Once enabled, the listed IP addresses (IPv4)

are allowed/denied access to the camera.

Select “Allow” or “Deny” from the drop-down list and click the “Apply” button to determine

the IP Filter behavior.

Add/Delete IP Address

Input the IP address and click the “Add” button to add a new filtered address. The Filtered IP

Addresses box shows the currently configured IP addresses. Up to 256 IP address entries

may be specified. To remove an IP address from the list, select the IP address and then click

the “Delete” button.

6.3.2.4 IEEE 802.1X

The camera is allowed to access a network protected by 802.1X/EAPOL (Extensible

Authentication Protocol over LAN). Users must contact the network administrator to obtain

certificates, user IDs, and passwords.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 146 147

Keine Kommentare

Quasar CM-3211 Series Installationshandbuch Seite 51